There are many new devices supported, some of them from Rockwell Automation and some are from other vendors like Zebra (Barcode Scanners) and Prosoft (MVI56E Communication Module). In response to Microsoft Distributed Component Object Model (DCOM) Hardening Patch (MS KB5004442), the minimum DCOM authentication level used by Rockwell Automation products was raised to Packet Integrity.įor the Product Notification about this from Rockwell Automation:įor the DCOM Changes from Microsoft in response to the security vulnerability in CVE-2021-26414: Mitigation for Microsoft DCOM Hardening Patch: For L8X Controller Redundancy, you will download the redundancy kit for v34.011.For L7X Controller Redundancy, you will download the redundancy kit for v34.051.Factory Talk View SE & FLEX Ex communication software are required for full alarming capabilitiesĪs with version 33, version 34 contains redundancy for both L7X and L8X ControlLogix controllers – see the release notes for exact models and information about minimum releases.I have found in more than one instance where software compatibility is a challenge after upgrading certain pieces of software.Įditor's Note: Always remember to take a snapshot you can roll back to before installing updates! Of course this assumes you are wisely using virtualization software like VMWare or Virtual PC. So if you have not upgraded your Windows 7 programming terminal, you will not be able to install version 34.Īs with other versions, check the software requirements for other Rockwell Software products that will be installed to be sure that those products are compatible with the prerequisite software installations with Studio v34. The main take-away here is that version 34 will not allow installation on any 32-bit system (including Windows 10) nor any Windows 7 system, period. That said, the software is expected to run and operate correctly (not tested) on other versions of Windows 10 (64-bit), Windows 7, Server 2008 R2, Windows 8, and Windows Server 2012 & 2016. The preferred operating systems for Studio 5000 v34 are Windows 10 Professional or Enterprise ( 64-bit,) and Windows Server 2019 Standard & Datacenter Image by: Brandon Cooper – v34 Installation As I tend to do with each release, I recently downloaded the software, read the release notes, and set out to install and test any new features that would be relevant to me in my process control endeavors. In March of 2022, Rockwell Automation released Studio 5000 Logix Designer version Thirty-Four.

Rockwell rslogix 5000 keydisc